tools recommended |
drop glue in holes for wood dowels on the end of the boards |
![](250/3.jpg) hammer in the wood dowels all the way in
Warning: Make sure to hammer the wood dowels all the way into the boards, (leaving about 3/8” out), to avoid damaging other boards.
Learningground is not liable if the installer misses this step.
|
![](250/4.jpg) hammer in the wood dowels in the toe kick boards |
put glue in the holes on the bottom shelf (with a slot) |
![](250/6.jpg) install the toe kick boards |
![](250/7.jpg) make sure the back toe kick board (no logo) on the side of the slot |
![](250/8.jpg) make sure the front toe kick board (with logo) line up in the front |
put glue in holes for wood dowels on the side boards
Warning: never hammer wood dowels directly on side boards, to avoid damaging the board from other side. |
![](250/10.jpg) install the magnet on the middle shelf boards (there are pre drilled holes) with 3/4" screws (provided) |
install the middle shelf board on the sideboard. make sure the rough side lines up with the slot for backboard. |
![](250/12.jpg) install the bottom shelf with toe kick boards
Make sure the magnet is facing the bottom shelf. |
install the other sideboard |
![](250/14.jpg) use rubber hammer or push the board by hand |
![](250/15.jpg) use power drill or wrench to fasten the 2" screws (provided) |
![](250/16.jpg) install the screws on the other side |
fasten the screws with power drill or wrench |
![](250/18.jpg) install the backside board |
![](250/19.jpg) |
![](250/20.jpg) install wood dowels with glue |
hammer in the wood dowels all the way down |
![](250/22.jpg) For the top part of the hutch: install the wood dowels on the side board of the top part of the hutch. (Recommend to push the wood dowels in by hand)
MARNING: In this step, do not hammer the wood dowel too hard, to prevent damaging the board from the other side. |
|
![](250/24.jpg) install the narrow board with glue |
make sure the rough edge of the narrow board line up the top of the board |
![](250/26.jpg) install the middle shelf board for the top part of the hutch |
![](250/27.jpg) fasten the shelf board with screws |
![](250/28.jpg) |
put glue in the hole for the wood dowel on the narrow board |
![](250/30.jpg) install the cam lock pins and wood dowel on the top board |
![](250/31.jpg) install the top part of the hutch |
fasten the top board with cam locks |
install the backboard for the top part of hutch |
![](250/34.jpg) |
![](250/35.jpg) fasten the bottom board for the top part of the hutch |
![](250/36.jpg) finished look for the top part of the hutch |
install top part of the hutch |
![](250/38.jpg) fasten the top with black screws (provided) |
![](250/39.jpg) install the doors with small screws (provided) |
![](250/40.jpg) install the other side |
install the magnet plat with small screw |
![](250/42.jpg) finished look of the hutch |
![](250/43.jpg) fasten the backboard with small screws in the pre-drilled holes |
|