tools recommended |
put glue in holes for wood dowels on the end of the boards |
hammer in the wood dowels all the way in
Warning: Make sure to hammer the wood dowels all the way into the boards, (leaving about 3/8” out), to avoid damaging other boards.
Learningground is not liable if the installer misses this step.
|
![](250/4.jpg) hammer in the wood dowels in the toe kick boards |
put glue in the holes on the bottom shelf (with a slot) |
![](250/6.jpg) install the toe kick boards |
![](250/7.jpg) make sure the back toe kick board (no logo) on the side of the slot |
![](250/8.jpg) make sure the front toe kick board (with logo) line up in the front |
put glue in holes for wood dowels on the side boards
Warning: never hammer wood dowels directly on side boards, to avoid damaging the board from other side. |
![](250/10.jpg) install the magnet on the middle shelf boards (there are pre drilled holes) with 3/4" screws (provided) |
![](250/11.jpg) install the middle shelf board on the sideboard. make sure the rough side lines up with the slot for backboard. |
install the bottom shelf with toe kick boards. Make sure the magnet is facing the bottom shelf. |
install the other sideboard |
![](250/14.jpg) install the other sideboard |
![](250/15.jpg) use power drill or wrench to fasten the 2" screws (provided) |
Turn the other side up and insert 2" screws |
fasten the screws with power drill or wrench |
![](250/18.jpg) install the backside board |
![](250/19.jpg) |
install wood dowels with glue in the holes on top of the boards. |
hammer in the wood dowels all the way down |
![](250/22.jpg) install the knobs in the center of the red and blue circles. Make sure do not screw the screws too tight, to let the knobs turn around. |
![](250/23.jpg) use glue for the wood dowels |
![](250/24.jpg) install the sink top |
secure with 2" screws |
![](250/26.jpg) use mullet or hand to push the sink top in |
![](250/27.jpg) fasten the black screws under the sink top |
![](250/28.jpg) lineup the hinge with the door |
fasten the door with small screws |
remove one of the metal plats from the magnet |
![](250/31.jpg) fasten the metal plat with a small screw close to the edge of the door (inside) |
![](250/32.jpg) turn the furniture the other way |
install the other door with small screws |
![](250/34.jpg) fasten the metal plat with a small screw close to the edge of the door (inside) |
![](250/35.jpg) secure the back board with small screws |
insert the tray in the opening of the sink top |
install the facet by twisting it into the hole. (you may need to trim the threads of the facet a little with a utility knife) |
![](250/38.jpg) |
|
|