tools recommended |
put glue in the holes on the bottom shelf (with a slot) |
![](250/3.jpg) hammer in the wood dowels in the toe kick boards |
![](250/4.jpg) install the toe kick boards |
make sure the back toe kick board (no logo) on the side of the slot |
![](250/6.jpg) make sure the front toe kick board (with logo) line up in the front |
![](250/7.jpg) put glue in the holes for the wood dowels at the two ends of the shelf boards |
![](250/8.jpg) put in the wood dowels |
Hammer the wood dowels in the holes all the way
Warning: Make sure to hammer the wood dowels all the way into the boards, (leaving about 3/8” out), to avoid damaging other boards.
Learningground is not liable if the installer misses this step.
|
![](250/10.jpg) install the magnet in the middle of the shelf board b following the pre-drilled holes. Use 3/4" screws provided |
![](250/11.jpg) put glue in holes for wood dowels on the side boards
Warning: never hammer wood dowels directly on side boards, to avoid damaging the board from other side. |
![](250/12.jpg) install the middle shelf boards on the sideboard. make sure the rough side lines up with the slot for backboard. |
make sure the shelf board with magnet is in the middle |
|
![](250/15.jpg) |
![](250/16.jpg) put the glue in on the other side-boards (with hinges) |
use power drill or wrench to fasten the 2" screws (provided) |
![](250/18.jpg) do the same for the other side |
![](250/19.jpg) install the backside board |
![](250/20.jpg) |
install wood dowels with glue |
![](250/22.jpg) hammer the wood dowels all the way in |
![](250/23.jpg) install the top board(with supporting bars), and turn the furniture upside down. |
![](250/24.jpg) fasten the top board with black screws |
lineup the hinge with the door |
![](250/26.jpg) install the metal plat for the magnet, by following the pre-drilled hole |
![](250/27.jpg) test and adjust the door with the magnate |
![](250/28.jpg) turn the furniture and do the same for the other door |
don't forget the plat for the magnate |
![](250/30.jpg) adjust the door if necessary |
![](250/31.jpg) secure the backboard with small screws |
![](250/32.jpg) |