Check all the boards: (back from left) 1 under board (with logo), 1 back board, 1 bench board, 2 left and right side boards, wood dowels, 2" screws |
drop wood glue in the holes on the back board |
put wood dowels in the holes on the board |
hammer the wood dowels in.
Warning: Make sure to hammer the wood dowels all the way into the end of the boards, (leaving about 3/8” out), to avoid damaging the side boards.
* Learningground is not liable if the installer misses this step. |
drop wood glue in the holes on the bench board
Warning: never hammer wood dowels directly on horizontal shelf boards, to avoid damaging the board from other side. |
hand push the back board on the bench board |
turn the two boards upward and put the 2" screws in the holes |
Fasten the screws with the wrench provided |
or use a hand drill |
drop the wood glue in the holes on the under board(with logo) |
hammer the wood dowels in. |
drop wood glue in the holes on the bench board |
Hand push the under board on the bench board |
It should look like this |
It should look like this |
Turn the board vertically and drop the wood glue in the holes on the boards |
Hand push the wood dowels in |
hammer the wood dowels in. |
drop the wood glue in the holes of the right side board |
install the right side board on the top of the vertical boards |
hand push or hammer with a mallet |
Fasten 2" screws with wrench provided |
or use a hand drill |
drop the wood glue in the holes of the left side board |
turn the installed boards upside down |
insert the wood dowels with glue |
install the left side board |
insert 2" screws |
Fasten 2" screws with wrench provided |
or use a hand drill |
|
|