Installation Guide

Check all the boards: (from left) 2 side boards, 1 toe kick board(with logo), 2 support boards, 1 top table board, 14 wood dowels, 10 2" screws

drop wood glue in the holes on the back side of the top table board

drop wood glue in the holes for the wood dowels on the 2 support boards

hand push the 2 support boards on the back side of the top table board

Warning: Make sure to hammer the wood dowels all the way into the end of the boards, (leaving about 3/8” out), to avoid damaging the side boards.
* Learningground is not liable if the installer misses this step.

do the same on the other side of the boards

do the same on the other side of the boards

hammer the wood dowels all the way into the 2 ends of the toe kick board(with logo)

Lay the table top on the side board

lay the toe kick board on the side board

lay the other side board on top of the vertical boards gently by hand

secure the boards with 2" screws

Fasten the screws with wrench

or use a hand drill. Make sure do both sides.